Do not follow these instructions if you are using a Control Panel like cPanel or DirectAdmin. Use the feature they provide for adding additional IP addresses instead
1. Determine what existing range files exist:
# cd /etc/sysconfig/network-scripts/
# ls ifcfg-eth1-range*
You will see at least one file, possibly several. Find the highest number following the "range" and add one to it. This will be the new range number. For example, if you see ifcfg-eth1-range0 and ifcfg-eth1-range1, your new range number will be "2". 2. Determine the next available interface number (clone number).
# ifconfig | grep eth1 You will see a list of interfaces that looks like this eth1 Link encap:Ethernet HWaddr 00:08:74:A3:29:70 eth1:0 Link encap:Ethernet HWaddr 00:08:74:A3:29:70 eth1:1 Link encap:Ethernet HWaddr 00:08:74:A3:29:70 . . . eth1:8 Link encap:Ethernet HWaddr 00:08:74:A3:29:70
Find the highest number after the "eth1:". Add one to it and this your new clone number. In this case it would be 9. 3. create a range file for the new range number. (for this example, we will use range2)
# vi ifcfg-eth1-range2
4. Write the following lines to the range file. (replace the dummy ip information with your desired ip range and the CLONENUM_START value with the one calculated above)
IPADDR_START='123.0.0.1' IPADDR_END='123.0.0.10' CLONENUM_START='9'
5. Write and quit the range file, and restart your network.
# /etc/init.d/network restart
6. Your new ips should now be visible by running:
# ifconfig
